Material Safety Data Sheet

Infosafe No™. K1H47 Issue Date: October 2010 ISSUED by SEPTONE CS: 1.4.95
Product Name: BLOC BITE

Not classified as hazardous according to criteria of NOHSC

   
   
         
         
         
   
   
   
   

1. IDENTIFICATION OF THE MATERIAL AND SUPPLIER

Product Name BLOC BITE
Product Code ISBB125, ISBB500
Company Name Septone Products Pty Ltd (ABN 50 009 745 537)
Address 44 Aquarium Avenue HEMMANT
QLD 4174
Emergency Tel. After hours only: (07) 3821 0623
Telephone/Fax Number Tel: (07) 3390 5044
Fax: (07) 3390 5041
Email general@septone.com.au
Recommended Use Insect repellent SPF16 sunscreen.
Other Information The information herein is, to the best of our knowledge, correct and complete. It describes the safety requirements for this product and should not be construed as guaranteeing specific properties. Since methods and conditions of application are beyond our control, Septone does not accept liability for any damages resulting from the use of, or reliance on, this information, in inappropriate contexts.

2. HAZARDS IDENTIFICATION

Hazard
Classification
Not classified as hazardous according to criteria of NOHSC
NON-HAZARDOUS SUBSTANCE.
NON-DANGEROUS GOODS.
Hazard classification according to the criteria of NOHSC.
Dangerous goods classification according to the Australia Dangerous Goods Code.
Risk Phrase(s) Not classified as hazardous according to criteria of NOHSC
Sensitization of
Product
None of the components of this product is considered to be a skin or respiratory sensitiser.
Teratogenicity None of the components of this product is considered to be a teratogen.

3. COMPOSITION/INFORMATION ON INGREDIENTS

Chemical
Characterization
Liquid
Ingredients Name CAS Proportion Hazard R Phrase
Water 7732-18-5 60-100 %
Ingredients determined not to be hazardous - 10-30 %
Paraffin oils 8012-95-1 0-10 %
N,N'-Diethyl-m-toluamide 134-62-3 0-10 %

4. FIRST AID MEASURES

Inhalation Unlikely route of exposure. Remove the victim from the source of exposure. If the victim is not breathing, apply artificial resuscitation.
Ingestion Do NOT induce vomiting. Give water to drink. Seek medical attention.
Skin Remove contaminated clothing and launder before re-use. Wash affected skin with soap and water.
Eye Hold the eyes open and flush with water for at least 15 minutes. Seek medical attention.
First Aid Facilities This Material Safety Data Sheet should be provided to the attending medical doctor.
Advice to Doctor Treat symptomatically.

5. FIRE FIGHTING MEASURES

Suitable
Extinguishing Media
Use the extinguisher appropriate to the principal fire hazard or to the source of the fire.
Special Protective
Equipment for fire
fighters
Firefighters are to wear protective equipment appropriate to fighting the primary fire hazard or the source of the fire. No special protective equipment required if this product is involved.
Specific Hazards None known.

6. ACCIDENTAL RELEASE MEASURES

Spills & Disposal Personnel involved in cleaning up any spills are to wear the appropriate protective equipment. Cordon off the spillage area. Isolate the source of the spillage or leak. Contain the spillage using a suitable non-flammable absorbent material such as sand or diatomaceous earth, and then transfer into sealed plastic containers for disposal. Dispose of large amounts in a chemical dump according to local authority statutory requirements. For small amounts, wash the product to the drain with a large excess of water.

7. HANDLING AND STORAGE

Handling and Storage Store in plastic containers in a clean, dry, cool, well ventilated place away from foodstuffs. Store below 30°C. Keep container closed when not in use.

8. EXPOSURE CONTROLS/PERSONAL PROTECTION

National Exposure Standards Name mg/m3 (STEL) ppm (STEL) mg/m3 (TWA) ppm (TWA) TWA Footnote
Water - - - -
Ingredients determined not to be hazardous - - - -
Paraffin oils - 5 -
N,N'-Diethyl-m-toluamide - - - -
Other Exposure
Information
Due to the form in which the product is supplied and used, the exposure limit for Paraffin Oils will not be reached.
Engineering Controls Natural ventilation adequate under normal conditions of use. Keep containers closed when not in use.
Personal Protective
Equipment
Not required under normal conditions of use. Wear gloves and chemical goggles if handling large amounts and if splashing is likely to occur.

9. PHYSICAL AND CHEMICAL PROPERTIES

Form Liquid
Appearance Off-white perfumed lotion.
Boiling Point 100°C
Solubility in Water Disperses
Specific Gravity 0.980 @ 25°C
pH Value 7.0
Evaporation Rate As for Water
Volatile Component 63% w/v
Flash Point This product will not flash and does not support combustion.
Flammability This product is not flammable under the conditions of use and does not support combustion.

10. STABILITY AND REACTIVITY

Chemical Stability Considered stable. Store below 30°C. Keep out of direct sunlight.
Conditions to Avoid None known.
Incompatible
Materials
None known.
Hazardous
Decomposition
Products
If this product is involved in a fire, the water contained in it may evaporate, leaving a residue which may combust, evolving carbon monoxide as well as other unidentifiable organic compounds.
Hazardous
Polymerization
Will not occur.

11. TOXICOLOGICAL INFORMATION

Inhalation Does not present an inhalation hazard.
Ingestion Irritant. Oral LD50 (rat) 1950 mg / kg for N,N'-diethyl-m-toluamide.
Skin Mild skin irritant. Some people with extremely sensitive skin may exhibit an allergic response such as an almost immediate development of a red rash or hives - if this occurs, the product should be washed off the skin with soap and water and the affected person should discontinue using the product. Dermal LD50 (rabbit) 3180 mg / kg for N,N'-diethyl-m-toluamide.
Eye Mild eye irritant. N,N'-diethyl-m-toluamide is a corneal irritant.
Chronic Effects Chronic dermal effects, particularly in children, have been reported for excessive dermal applications of highly concentrated levels of N,N'-diethyl-m-toluamide. These effects include toxic encephalopathy (inflammation of the cranial tissue). N,N'-diethyl-m-toluamide can be absorbed through the skin, and due to the potential toxicity of N,N'-diethyl-m-toluamide, frequent total-body applications of Bloc Bite, especially on children, for days or weeks should be avoided.
Reproductive
Toxicity
None of the components of this product is considered to be toxic to the unborn foetus.
Mutagenicity None of the components of this product is considered to be a mutagen.
Carcinogenicity None of the components of this product is considered to be a carcinogen.

12. ECOLOGICAL INFORMATION

Short Summary of
Assessment of
Environmental Impact
The major organic components of this product are expected to be readily biodegradable and to exhibit low aquatic toxicity. No potential for bioaccumulation is expected.

13. DISPOSAL CONSIDERATIONS

Product Disposal Dispose of large amounts in a chemical dump according to local authority statutory requirements. For small amounts, wash the product to the drain with a large excess of water.
Container Disposal After rinsing with water the empty container may be recycled.

14. TRANSPORT INFORMATION

Transport
Information
This product is classified as non dangerous according to the ACTDG and according to the IMDG Code.
IMO Marine Pollutant None of the components of this product is considered by IMO to be a Marine Pollutant.

15. REGULATORY INFORMATION

Poisons Schedule Not Scheduled
AICS (Australia) To the manufacturer's best knowledge, all components of this product are listed on AICS.

16. OTHER INFORMATION

Contact Person/Point Technical Manager (07) 3390 5044
Other Information Test the product on a small area of skin first in order to ensure no adverse skin reaction. Wash the treated skin with soap and water and seek medical advice if you suspect that your skin has reacted adversely to the product. If a skin rash develops or irritation occurs, discontinue using the product. Do not apply the product on cuts, wounds or irritated skin. Do not apply the product to the eyes, lips, mouth or groin area, or to the hands of younger children. Wash the treated skin with soap and water after returning indoors. This is particularly important if the product is applied day after day.

...End Of MSDS...


(C) Copyright ACOHS Pty Ltd
Copyright in the source code of the HTML, PDF, XML, XFO and any other electronic files rendered by an Infosafe system for Infosafe MSDS displayed is the intellectual property of Acohs Pty Ltd.
Copyright in the layout, presentation and appearance of each Infosafe MSDS displayed is the intellectual property of Acohs Pty Ltd.
The compilation of MSDS's displayed is the intellectual property of Acohs Pty Ltd.
Copying of any MSDS displayed is permitted for personal use only and otherwise is not permitted. In particular the MSDS's displayed cannot be copied for the purpose of sale or licence or for inclusion as part of a collection of MSDS without the express written consent of Acohs Pty Ltd.