| | | | | | | | |
|
| 1. IDENTIFICATION OF THE MATERIAL AND SUPPLIER |
|
| Product Name |
FIBREGLASS POLISH - SUPERFINE |
| Product Code |
MPFS500, MPFS18 |
| Company Name |
Septone Products Pty Ltd (ABN 50 009 745 537) |
| Address |
44 Aquarium Avenue HEMMANT
QLD 4174 |
| Emergency Tel. |
(07) 3821 0623 |
Telephone/Fax
Number |
Tel: (07) 3390 5044
Fax: (07) 3390 5041 |
| Email |
general@septone.com.au |
| Recommended Use |
High gloss paste polish without abrasive. |
| Other Information |
The information herein is, to the best of our knowledge, correct and complete. It describes the safety requirements for this product and should not be construed as guaranteeing specific properties. Since methods and conditions of application are beyond our control, Septone does not accept liability for any damages resulting from the use of, or reliance on, this information, in inappropriate contexts. |
|
| 2. HAZARDS IDENTIFICATION |
|
Hazard
Classification |
Not classified as hazardous according to criteria of NOHSC
NON-HAZARDOUS SUBSTANCE.
NON-DANGEROUS GOODS.
Hazard classification according to the criteria of NOHSC.
Dangerous goods classification according to the Australia Dangerous Goods Code. |
| Risk Phrase(s) |
Not classified as hazardous according to criteria of NOHSC
|
Sensitization of
Product |
None of the components of this product is considered to be a skin or respiratory sensitiser. |
| Teratogenicity |
None of the components of this product is considered to be a teratogen. |
| Other Information |
Because the viscosity of this product is such that it will not flow through a flow cup and it is greater than 0.000007 m2/sec or 7 cst at 40°C, the risk phrase R65 and the safety phrases S2-S23-S24-S62 do not apply to this product - refer to p25 of NOHSC:1008(2004). |
|
| 3. COMPOSITION/INFORMATION ON INGREDIENTS |
|
Chemical
Characterization |
Solid |
| Ingredients |
Name |
CAS |
Proportion |
Hazard |
R Phrase |
| | Water |
7732-18-5 |
30-60 % |
|
|
| | Ingredients determined not to be hazardous |
- |
10-30 % |
|
|
| | White Spirit (Stoddart Solvent) |
8052-41-3 |
10-30 % |
Xn |
R65 |
| | Kerosene |
8008-20-6 |
10-30 % |
Xn |
R65, R48 |
|
| 4. FIRST AID MEASURES |
|
| Inhalation |
Remove the victim from the source of exposure. If the victim is not breathing, apply artificial resuscitation. |
| Ingestion |
Do NOT induce vomiting. Give water to drink. Seek medical attention. |
| Skin |
Remove contaminated clothing and launder before re-use. Wash affected skin with water. |
| Eye |
Hold the eyes open and flush with water for at least 15 minutes. Seek medical attention. |
First Aid
Facilities |
This Material Safety Data Sheet should be provided to the attending medical doctor. |
| Advice to Doctor |
Treat symptomatically. |
|
| 5. FIRE FIGHTING MEASURES |
|
Suitable
Extinguishing
Media |
Use the extinguisher appropriate to the principal fire hazard or to the source of the fire. |
Special
Protective
Equipment for
fire fighters |
If this product is involved in a fire, firefighters should wear full protective equipment including self-contained breathing apparatus. |
| Specific Hazards |
As this product is an oil-in-water emulsion, it is not flammable under the conditions of use and does not support combustion. However, if the emulsion breaks then the flash point of the solvent layer will be that for White Spirit, which is 35°C (ASTM D-56). |
|
| 6. ACCIDENTAL RELEASE MEASURES |
|
| Spills & Disposal |
Personnel involved in cleaning up any spills are to wear gloves and goggles. If there is the possibility of a fire, then personnel should also wear self-contained breathing apparatus. Cordon off the spillage area. Isolate the source of the spillage or leak. Contain the spillage using a suitable non-flammable absorbent material such as sand or diatomaceous earth, and then transfer into sealed plastic containers for disposal. |
|
| 7. HANDLING AND STORAGE |
|
Handling and
Storage |
Store in plastic containers in a clean, dry, cool, well ventilated place away from foodstuffs. Keep container sealed when not in use. |
|
| 8. EXPOSURE CONTROLS/PERSONAL PROTECTION |
|
| National Exposure Standards |
Name |
mg/m3 (STEL) |
ppm (STEL) |
mg/m3 (TWA) |
ppm (TWA) |
TWA Footnote |
| | Water |
- |
- |
- |
- |
|
| | Ingredients determined not to be hazardous |
- |
- |
- |
- |
|
| | White Spirit (Stoddart Solvent) |
- |
- |
790 |
- |
|
Other Exposure
Information |
Under normal storage and use conditions the exposure standards for the solvents will not be reached. |
Engineering
Controls |
Natural ventilation adequate under normal conditions of use. Keep containers closed when not in use. |
Personal
Protective
Equipment |
Not required under normal conditions of use. Wear impervious gloves and chemical goggles if handling large amounts and if splashing is likely to occur. |
|
| 9. PHYSICAL AND CHEMICAL PROPERTIES |
|
| Form |
Solid |
| Appearance |
Smooth off-white paste, slight solvent odour. |
| Boiling Point |
100 - 250°C |
Solubility in
Water |
Disperses in Water |
| Specific Gravity |
0.900 @ 25°C |
| pH Value |
7.7 |
| Evaporation Rate |
As for Water |
| Volatile Component |
81% w/w |
| Flash Point |
This product will not flash and does not support combustion. |
| Flammability |
As this product is an oil-in-water emulsion, it is not flammable under the conditions of use and does not support combustion. However, if the emulsion breaks then the flash point of the solvent layer will be that for White Spirit, which is 35°C (ASTM D-56). |
|
| 10. STABILITY AND REACTIVITY |
|
| Chemical Stability |
Considered stable to heat and light. Store below 30°C. Keep out of direct sunlight. |
Conditions to
Avoid |
None known. |
Incompatible
Materials |
Strong oxidising agents. |
Hazardous
Decomposition
Products |
During combustion, this product may produce carbon monoxide as well as other unidentifiable organic compounds. |
Hazardous
Polymerization |
Will not occur. |
|
| 11. TOXICOLOGICAL INFORMATION |
|
| Inhalation |
Does not present an inhalation hazard. The exposure standard for White Spirit is 790 mg/m³ (TWA) (Source: NOHSC, under review). However, under normal storage and use conditions this standard will not be reached. |
| Ingestion |
Irritant. Oral LD50 (rat) > 2000 mg / kg for White Spirit. |
| Skin |
Essentially non irritating. Dermal LD50 (rat) > 2000 mg / kg for White Spirit. Primary irritation index for White Spirit (rabbit): greater than 0.5 but less than 3.0. |
| Eye |
Mild eye irritant. Draize score for White Spirit: greater than 6 but less than 15. |
| Chronic Effects |
Prolonged and constant use may lead to irritation and possibly dermatitis. |
Reproductive
Toxicity |
None of the components of this product is considered to be toxic to the unborn foetus. |
| Mutagenicity |
None of the components of this product is considered to be a mutagen. |
| Carcinogenicity |
None of the components of this product is considered to be a carcinogen. |
|
| 12. ECOLOGICAL INFORMATION |
|
Short Summary of
Assessment of
Environmental
Impact |
Expected to have low toxicity to aquatic organisms. The hydrocarbons contained in this product are biodegradable, degrading rapidly in air by photo-chemical means. However, use this product in accordance with standard industrial practices and avoid product dispersion in the environment. |
|
| 13. DISPOSAL CONSIDERATIONS |
|
| Waste Disposal |
Dispose of large amounts in a chemical dump according to local authority statutory requirements. For small amounts, wash the product to the drain with a large excess of water. |
|
| 14. TRANSPORT INFORMATION |
|
Transport
Information |
This product is classified as non dangerous according to the ACTDG. |
IMO Marine
Pollutant |
None of the components of this product is considered by IMO to be a Marine Pollutant. |
|
| 15. REGULATORY INFORMATION |
|
| Poisons Schedule |
Not Scheduled |
| AICS (Australia) |
To the manufacturer's best knowledge, all components of this product are listed on AICS. |
|
| 16. OTHER INFORMATION |
|
Contact
Person/Point |
Technical Manager (07) 3390 5044 |
| Other Information |
Keep container sealed when not in use. |